to power on the remote simply flip the switch located on the top right of the device to the on position.
to switch between channels, flip the switch located on the top of the device to the desired channel.
Turning the knob counterclockwise will operate your train counterclockwise, turning knob clockwise will operate train clockwise.
Pressing numbers 1-6 on the remote will play six different sounds.
to connect your track to the track power receiver connect the wires from your track to the area on the screw terminal labeled "Track."
The Receiver is set to channel 1 by default. To change the channel of the receiver please read the document that explains this process in detail.
Direction LED's tell you the state your train track. If the center LED(Red) is on, it means the train is stopped. The left and right LED's indicate the direction in which the train is moving.
Please review the documents below for manuals and instructions.
To power on the Audio Board simply flip the switch located on the top right of the device to the on position.
to switch between channels, flip the switch located on the top of the device to the desired channel. A step by step instruction document is located in the documents below.
The SD card comes pre-loaded with six different sounds. To change them or even create your own recordings follow the detailed documents below.
You can play the sounds two in two ways. Pressing the push button on the Audio Board will cycle through the different sounds stored in the SD card. Pressing the numbers 1-6 on the train remote will play the six different sounds.
308 B Brighton Avenue
Buffalo, Minnesota 55313